FIGJAM wrote:The easiest way to compensate for the angle on your container is to stick some foam rubber around where you want to seal it to the wall.
The foam will give enough for you to just push the cooler against the hole in the wall for a good seal.
captain mcguiver wrote:Cool bin, where did you pick that up?
Love the clear bin. Question: how do you plan to compensate for the inward slope of the bin vs the flat wall of your structure? I'm in the same boat and would love your thoughts.
Bring your swamp cooler or come to learn! Meet the fabulous people from the epic eplaya thread! Fix, troubleshoot, and invent!
FIGJAM wrote:YURT ALERT!!!!! Ok you dont have to have a yurt, but I liked saying it. Swamp cooler 2.0.
I made the box out of some left over material from my tub surround. I dont remember what its called, but its water proof and light. Fiber glass or plastic panels will work if their thick enough, but if you are patient, look in the thrift stores for a plastic or lexan display case with roughly the same dementions. 15x15x24in. Then you wont have to build a box.
The endless breeze fan is awsome. I thought I had a problem with it, but it turns out that I reversed the connection which made the fan run backwards, so it wasnt pushing much air. Now I can feel the breeze from 10ft away when its on low(1.18 amps 250cfm) medium 500cfm 1.68 amps, and high is 900cfm at 2.50 amps. Great for a 12 volt fan. The cheepest price new that I found was $60. Mine was a display and I got it for $25.
1/2in. pvc and three 90s and a cap.
The feed line was a little small till I put a short piece of pvc in the 90. with a little sillycone, its perfect. No need to glue the other pvc parts together.
By folding the pad instead of cutting individual pieces, It gets a snugger fit. The piece of strap keeps the pad snug at the front of the cooler. This is needed because if your fan is real strong, it will try to vacume your pad away from the sides. The pad retains its shape real well, so folding the inside corners is perfect.
The black tape is there because I got a little high on the sides with my holes and you want all the air to be drawn through damp pad.
Im waiting for the little bit stronger pump so I can test, but it should work fine...........FIGJAM........Oh .....check rv places to locate this fan. I sillyconed all the joints on the box exept the lid and this unit holds 8 gal. of water. Theres room for a case of pbr in the bottom. I have to check, but I think the water temp when running is close to 40 degrees. Unite dry wieght 13 pounds.
FIGJAM wrote:The pumps just arrived! I installed one on the new cooler and I cant think of any way it could be more suited to this purpose.
It uses .23amps and has a built in filter. Cost $14.95. Heres a pic of the pad to give an idea of how porse it is.
If you want your controls to be inside your structure cut the box with an extention where you will attatch the fan. this is how I set mine up.
I didnt need an extention. I tried it without the shade clothe first. When I had just the pump on there was minor leaking untill I turned the fan on low and the leaking stopped. If I sand the holes it may stop that entirely as any little snag tends to direct a small leak. And now the best part.....
The cooler on low (1.4 amps with the pump) is setting on the desk in the background and is about 4ft. away, but I couldnt get a good pic of the temp with the cooler in the shot. But damn AM I EVER HAPPY HAPPY WITH THIS THING...............FIIIIIIIIIIIIIIIIIIGJAM............
Users browsing this forum: No registered users and 3 guests