Hello, again, friends.
I will wish you all a joyous and successful new year.
I am here with a mixed result report:
We had a wonderful first attempt, even at this small scale.
we achieved a modicum of success in stabilization, as flow began, allowing the shock wave to propagate, and then, much to our delight, synchronize, as indicated by the simultaneous firing on our indicator L.E.D lights for brief periods.
During those periods, we measured a full 2 amperes of load to our simple device.
What an exciting time that was.
We feel that more power may well have been available, but, shortly following the full actuation of the device (I will detail the device shortly), a small, seemingly insignificant mechanism failed, and, our test was subsequently halted. We don't feel the test failed, since, the problem were related to an hardware/mechanical failure of one of the few devices we have in our mechanism that we have not created our selves.
It was a simple, foreign made switching relay, obviously made with inferior materials.
We will not encounter that issue again, as, we have decided to fabricate, or, purchase locally, from known vendors, all parts possible.
So, with that, we do have a setback.
We will have to re-create this first phase testing, so as to prove our result repeatable, and, to ascertain the actual level of power possible to generate, using our principles.
However, in my opinion, a spectacular first attempt, and, results matching our hopes.
to detail the simple mechanical device, which was mine own idea, for a visual examples the energy produced:
in series, was connected to a 1cm diameter, 4cm in length wooden dowel, first a small L.E.D. light, at one end.
Next, the dowel was connected to an eccentric wheel mounted on a low speed, motor,
and finally, a small acoustic vibrating device.
each have a threshold resistor separating them, so, as power increased, the L.E.D would light, followed by the motor spinning, allowing the dowel to rise and fall (so as to prove power to move against the resistance of gravity and friction of the system), and, finally, the acoustic device would signal a total power draw of 2 amperes.
Imagine our delight as one by one, the L.E.D. lit, then the dowel began it's reciprocating motion, followed by the audible confirmation of full power.
We all enjoyed an actual visual and auditory example, along with the required gauges and indicators.
Unfortunately, very shortly after the final indicator sounded, the previously mentioned "foreign made" part, failed.
We were disappointing, but realized, that, considering the speed at which each threshold was reached and surpassed, more power was undoubtedly possible.
As to the concerns stated regarding our "shockwave", I sadly can not give much detail, as, it is within the unique process we are attempting to patent. Please, though, rest assured, it is not a dangerous thing, and, is initiated by simple low level magnetism, and, is not related to explosion, but, more so to the application of sequential energizing of magnets.
We also see no indication or possibility of an acoustic effect surrounding or emanating from our device.
Although, in consideration of same, I will suggest to my mentor, we include acoustic recording and monitoring device, to determine any effect or manifestation.
I will close for now,
hoping to have definitive results to report, upon completion of our next attempt at first phase testing.
Also, Mr. Jellyfish Mister and Dusty Bacon:
I have received your samples, and, they are as described.
May I, though, impose on you another task?
It would be helpful, to ascertain the soil composition and water saturation at one meter depth. We are concerned that the soil is chemically similar to the surface material at that depth, as well as the compaction and moisture content.
Would it be possible, to, have a core sample, sealed and shipped?